The following 10 Gb Ethernet top-of-rack switches are supported. SUSE Linux Enterprise Server 11 with Xen for AMD64/EM64T SUSE Linux Enterprise Server 11 for AMD64/EM64T Red Hat Enterprise Linux 6 Server 圆4 Edition Broadcom Single Port 10 GbE SPF+ Embedded Adapter for System x The adapter is ideal for solutions where price sensitivity is paramount and where port-level redundancy is not required.įigure 4. The Broadcom Single Port 10 GbE SPF+ Embedded Adapter for System x is shown in the following figure. This support enables the sharing the network interface with the IMM2 and the operating system, thereby eliminating the need for a separate management network (ML2 and Mezzanine cards only) Support for Network Controller Sideband Interface (NC-SI) for communication with the server's onboard IMM2 management processor.Management using Broadcom Advanced Control Suite management application.Link Aggregation Control Protocol (LACP) and generic trunking.
Network teaming, failover, and load balancing.IEEE 1588 Precision Time Protocol (PTP)-Ready.Preboot eXecution Environment (PXE) support.Wake on LAN (ML2 and Mezzanine cards only).VXLAN and NVGRE offload technology support (not supported with UFP).Message signal interrupt (MSI, MSI-X) support.UDP/IP checksum offload for IPv4 and IPv6.TCP/IP checksum offload for IPv4 and IPv6.Receive-side scaling (RSS) for IPv4 and IPv6.Supports SR-IOV with up to 64 virtual functions per 10GbE link.Supports Switch-independent NIC partitioning (NPAR) with up to four partition assignments per 10GbE link.Ethernet frame: 1500 byte or 9600 byte (jumbo frame).PCI Express 2.0 x8 host interface (5 GTps).SFP+ port supporting fiber optic and direct-attach copper (DAC) cables.The PCIe adapter is supported in a low-profile PCIe adapter slot in a wide variety of System x servers.ML2 (Mezzanine LOM Generation 2) adapters are supported in selected System x servers where the adapter is installed in a dedicated slot.
Hp probook 4510s and broadcom drivers hi, am trying to get the broadcom 4310.